Hot Sale Dry Powder Mixing Equipment

hot sale  dry powder mixing equipment

Main application
    This machine is a new type of high efficiency & high precision mixing equipment, widely used in pharmaceutical, chemical and foodstuff for all kinds of powder mixing.
 
Characteristics
              This machine auto-rotation and orbit motion is form by a motor and cycloidal pinwheel reduction box, with large stirring range and high mixing speed. Characteristics for example
Advanced structure, easy operation, security; there is no gearing at the bottom, avoiding the leakage of the powder;
Low power consumption;
Mixing fast and even; two augers are arranged unsymmetrical. Thus, it can mix the several powders with great disparity on the proportion well;
Fray the granula tinily; suitable for the heat-sensitive material;
Good sealing, easy cleaning and maintenance; the jacket for drying or cooling is available.
Structure
1,This machine consists of cycloidal pinwheel reducer, feeding mouth, screw gear, stir screw and discharging valve.
2,The machine make the mixed materials move up  and  down and helical motion through two hybrid direction (the auto-rotation and orbit motion) , thus to achieve the ideal mixing effect.
 
 Installation & Commissioning
1. Make sure the machine is placed on the flat ground. Don't start the machine before fix the body.
2. Check the joints of the bolts and screw whether is tightly or not.
3.Before using the machine, should check inside the tube whether is clean or not, and  whether entrainment sundry at screw transmission parts.
4. Start it without material first, after it running normal then start to produce with material through the charging door.
5.Equipment charging shall not exceed two-thirds of the barrel body, mixed for 6-10 minutes general.
6.When equipment normal operation, long screw rotation direction is upward spiral, short screw rotation direction is downward spiral.
(Note: Remember to start the machine after it is running normal instead of after charging!)
 
 Technical parameters
 
 Repair and Maintenance
1.          Before the test run, it is necessary to make a thorough inspection, whether the bolts are fastened, whether there is any damage to the components.
2.          After operating 100 hours, should check all the nuts, bolts and fasteners of the machine thoroughly insure there's no loose, it is necessary to tighten them timely.
3.          Don't allow to boot before loading screen box or the fixed pressure foot is not fastening.
4.          Don't allow the case of super-load working.
5.          Don't allow to carry out any adjustment when the machine is running.
6.         After electricity, if there's an abnormal phenomenon, please check on the basis of the wiring diagram immediately